Very Simple Running RABBITS!
Rabbits
1. Target Plate are
1/2" thick circle plates. Diameters of 6", 8" or 10" can be used.
Rabbit
Track
2. Rabbit Track is 2
- 3/16" x 1 1/2" x 2 1/2" x 96" "L" angle iron
5/8" apart for full length.
3. Rabbit Track is held together
with 3/16" x 3" flat bar welded to bottom
of 2 "L" angle iron.
4. Pull Pin attached
to trigger knockdown target.
5. Spikes to hold Rabbit Track
in place.
Trigger
Target
6. You will need a falling
plate target to release rabbit by pulling pin out of track.
Prop
to Raise End of Rabbit Rabbit Track
7. I use hay bales for this.
I also put hay bales or some sort of prop in front of Rabbit Track so the
shooter
does not see the rabbit until it clears the track rolling and bouncing
across the bay. |