Can Tosser    by Cliff Hanger                             back to Photos
 
                                        RED is common soda can.

1. Target plate is 1/2" x 6" x 6"                         flat bar
2. Shield Plate is 1/4" x 2" x 6" flat bar       10. 2 @ 1/8" x 1.5" x 2"
3. Base Shield is 3/16" x 4" x 8" angle          11. 2 @ 1/8" x 2" x 8"
4. Base channel is 3" x 6" 
                                                                        pipe
    72" of 1" angle iron.                                  12. 1 @ 3/8" x 2" 
5. 1 @ 6" 
6. 2 @ 8"                                                          bolts
7. 2 @ 14"                                                    13. 1 @ 3/8" x 3"
8. 2 @ 15"                                                    14. 2@ 3/8" x 1"
                                                                    15. 6 @ 1/4" x 1"
    1" square tubing or other support
9. 1 @ 4"                                                           wood is cabinet grage 9 ply 
                                                                    16. 1 @ 5/8" x 1 7/8" x 15.5"
       BOLTS 
#13 goes through 10-12-10
#14 goes through 2 sides of 8 - 6 (hinge)
#15 goes through 11 top - 16 - 11 bottom

NOTE: Put 4" angle base shield on last. Place Can on base then shim 3/16" on both sides touching 4" angle base shield before welding.